M&M Cycles is now Mozaic Racing! Read About Us.

Feuling Vented Dipstick

Feuling Vented Dipstick

This part is bike specific. It will not fit all makes / models / years.

If you enter fitment information, we'll only show you the options that work for your bike.

$ 247.34 Reg $ 279.95 $ 32.61 Savings Enter your bike's fitment to see our inventory levels. Free Shipping Eligible! $0.00 Tax Collected Outside Ohio
Add to Cart

Product Overview

Screws into the factory oil fill spout as a stock replacement part on M-Eight baggers
This breathing dipstick removes unwanted build-up of blow by, which is found in engines with excessive leak down through the rings/cylinders which is a common issue with large displacement big bore engines
Test results show a decrease in engine sump oil levels
Dipstick vents excessive pressure from the oil tank through a breather system consisting of a filter element and umbrella valve

Choose from two venting style options when installing the dipstick

Option 1 is to use the 1/8 NPT breather vent fitting with internal porous filter element (this option gives a clean look; however it can produce an oil misting/residue out of the element on engines with excessive leakdown/blow by)

Option 2, is to use quick-disconnect coupler fitting with rubber hose and filter element (this option will run any excessive oil misting/residue through the line and into the filter element, but does requires disconnecting the fitting in order to check the oil)

For option 2, we recommend routing the line up the frame rail, up under the seat/abs area then back down along the right side frame rail and the filter element can fit cleanly between the engine/trans matting area on the inside of the lower right frame rail

There are two ways to read the oil level with this dipstick, with the bike on the jiffy stand (FHS) or the bike upright and level (FHU)
If reading the dipstick with the bike on the jiffy stand you will take your reading from the dimples labeled FHS (Full Hot Stand)
When reading the dipstick with the bike upright and level you will take the reading from the dimples labeled FHU (Full Hot Upright)

Made in the U.S.A.

The oil pick-up port is on the right side of the engine. Letting the bike idle or warm up on the kickstand will naturally fill the engine case and skew the oil level in the tank.

FREE SHIPPING

FREE shipping on orders over $150 within the continental U.S. We ship Worldwide!
FITMENT GUARANTEE

We guarantee our product will fit on your vehicle our we pay return shipping.
LOW PRICES

Shop Mozaic Racing for Parts and Accessories for your Harley, Indian, Sport Bike, or Metric.